Here you will find articles on how to solve specific issues related to ESI's software solutions. Missing ESI products will be added progressively. Each article has a short abstract which is accessible to everyone. As logged users you can see the full article with all attached screenshots, and you can post comments related to each article.
To simulate bolt pretension, a new medium called PRELOAD has been developed.
With this medium, the strain generating the pretension is automatically computed and applied on the model.
As existing 2D Combine in Visual-Mesh, 3D Combine has been introduced to undone refinements.
The aim of this new 3D pattern is to allow users to refine mesh on a restricted area
The computation manager help users to generate the computation input with parameters adapted to the model to study
The objective of this interface is to perform a restart with ABAQUS using a SYSWELD computation. The difficulty is to transfer the metallurgical effects in a data structure which is not designed for it.
Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.
This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by...
The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding...
In case of butt joint of two plates, in reality, there is an eccentricity e between the neutral phase of bending and the centre of the tendon force caused by the weld which causes the typical horse saddle of a butt welded flat plate..
A functionality Delta T Offset ...
It is not straightforward to do the conversion Files .fdb in .erfh5 on Network Drive in Visual Viewer.
In order to make it work properly, it is necessary to map network drive to the local machine. In this way, the files on network could be handled like on local...