Tips & Tricks

Here you will find articles on how to solve specific issues related to ESI's software solutions. Missing ESI products will be added progressively. Each article has a short abstract which is accessible to everyone. As logged users you can see the full article with all attached screenshots, and you can post comments related to each article.

Static comfort – Different encrypted data display
How to display encrypted occupant when other data are also encrypted in the model.
Oriane Jammet-Reynal
Virtual Seat
55

Static Comfort - Sensors Grid
Sensors Grid Definition improvement in Virtual Seat Solution v2015 (VE 11)
Cécile Cabane
Virtual Seat
141

Trim Manufacturing – Trim Adviser
Trim Adviser improvement in Virtual Seat Solution v2015 (VE 11)
Cécile Cabane
Virtual Seat
142

Internal injection lines modeling
Internal injection lines on a shell model (i.e. made of internal element edges) are not supported by the parallel solver.
Mathilde Chabin
Composites
316

Direct Opening of a mesh
The creation of a RTM project and loading of the model mesh is usually done in 2 steps.
Mathilde Chabin
Composites
276

Coupling between PAM-FORM and PAM-RTM: multiple part mapping
Coupling between PAM-FORM 2G and PAM-RTM is done through a .DSY file. Thus, pre-forming process is simulated with PAM-FORM 2G and resulting fiber orientations that will affect permeabilities are transferred to PAM-RTM model setup.
Mathilde Chabin
Composites
349

How to report and talk about simulation time in an objective manner
Reporting or talking about simulation time is a difficult subject. In the article a way to manage this problem in an objective manner is given.
Harald Porzner
Welding & Assembly
710

Materials in the database - Which material properties to use with respect to the three methods to simulate the heat effects of welding
A material is described with exactly one set of material properties. In simulation engineering - depending on the applied method and the moment in time when the simulation is carried out in the product development cycle - only subsets of a full material data set might...
Harald Porzner
Welding & Assembly
892

The transient method – the third out of three methods to simulate the heat effects of welding
In order to meet different requirements from first design to start of production, three different methods are available in the Virtual Welding & Assembly Suite from ESI. The third one – the transient method – is used when not only distortion but also residual...
Harald Porzner
Welding & Assembly
586

The instantaneous method – the second out of three methods to simulate the heat effects of welding
In order to meet different requirements from first design to start of production, three different methods are available in the Virtual Welding & Assembly Suite from ESI. The second one – the instantaneous method – is used when not only distortion but also residual...
Harald Porzner
Welding & Assembly
509