CFD-FASTRAN
ProCAST
SYSTUS
Visual-Environment
SYSWELD
Here you will find articles on how to solve specific issues related to ESI's software solutions. Missing ESI products will be added progressively. Each article has a short abstract which is accessible to everyone. As logged users you can see the full article with all attached screenshots, and you can post comments related to each article.
Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.
This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by...
The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding...
It is not straightforward to do the conversion Files .fdb in .erfh5 on Network Drive in Visual Viewer.
In order to make it work properly, it is necessary to map network drive to the local machine. In this way, the files on network could be handled like on local...
On Linux, at moment of launching Visual-Environmnet, crash happens after having selected Visual Weld.
It is possible to try following steps to solve the problem.
- Launching Visual in debug mode
- Downgrade GlibC to 2.12
- Install freshly NTP
Easily creating a connection between a tetramesh and an hexamesh is possible, using Boundary Layer Mesh tool.
When comparison between results is needed, coupling windows and synchronizing animations is a key tool.
Reporting or talking about simulation time is a difficult subject. In the article a way to manage this problem in an objective manner is given.
A material is described with exactly one set of material properties. In simulation engineering - depending on the applied method and the moment in time when the simulation is carried out in the product development cycle - only subsets of a full material data set might...
In order to meet different requirements from first design to start of production, three different methods are available in the Virtual Welding & Assembly Suite from ESI. The third one – the transient method – is used when not only distortion but also residual...