Tips & Tricks

Here you will find articles on how to solve specific issues related to ESI's software solutions. Missing ESI products will be added progressively. Each article has a short abstract which is accessible to everyone. As logged users you can see the full article with all attached screenshots, and you can post comments related to each article.

e-Café #2 - Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP
Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP
Julien Charbonneaux
Sheet Metal Forming
8

e-café #1 - Réaliser une mise en données en 5 minutes en utilisant le workflow PAMSTAMP
Presse simple effet avec PAMSTAMP
Julien Charbonneaux
Sheet Metal Forming
3

Interface SYSWELD / ABAQUS
The objective of this interface is to perform a restart with ABAQUS using a SYSWELD computation. The difficulty is to transfer the metallurgical effects in a data structure which is not designed for it.
Yonggang Duan
Welding & Assembly
84

How to Obtain Best Results within Reasonable Time from a Heat Treatment Simulation
Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.
Yonggang Duan
Welding & Assembly
35

Stamping/HT Chaining of 3D Ring - Restart tool in Visual Heat Treatment
This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by...
Yonggang Duan
Welding & Assembly
36

Heat Power display in Visual Weld
The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding...
Yonggang Duan
Welding & Assembly
41

Improve trimming with Overshoot
Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.
Matthias Hoss
Sheet Metal Forming
123

PAM-STAMP solver 2018.0.1 - Troubleshooting
Recommended file exchange in case of unexpected solver stop without error message. MPI change in case plateform mpi issue in DMP
Martin Holecek
Sheet Metal Forming
286

Conversion Files .fdb in .erfh5 on Network Drive
It is not straightforward to do the conversion Files .fdb in .erfh5 on Network Drive in Visual Viewer. In order to make it work properly, it is necessary to map network drive to the local machine. In this way, the files on network could be handled like on local...
Yonggang Duan
Multiphysics, Welding & Assembly
63

Smart computing with PAM-STAMP
Tips and tricks to reduce computational time for PAM-STAMP input files.
Vladimir Cerny
Sheet Metal Forming
327