Tutorials and Model Library
Getting_Started_with_wax_injection
Wax Injection (for wax patterns) is very similar to the HPDC process, however, the registered pressure inside of the cavity while filling is much lower.
This is caused by the much different properties of wax compared to any metal alloy material.
When modelling wax injection, the user...
Casting
Getting Started with ProCAST NAPM
The goal of this tutorial is to show a typical setup of NAPM for gravity casting.
Casting
Getting Started with ProCAST EMAG
The focus of this training is to introduce the usage of the ProCAST's low frequency electromagnetic edge element solver (EMAG) inside Visual Environment.
The main features of the module are presented while describing the main fields of application.
Two examples are included, whic...
Casting
Getting Started with ProCAST General Usage
This document introduces the general usage of Visual Cast for ProCAST
This document focuses on analysis setup. Therefore, there is no meshing information.
The focus is made on model set up. The handling of geometry is not shown.
Casting
Getting Started with ProCAST Visual Mesh
The goal of this tutorial is to show a typical usage of Visual-Mesh Application for Casting Modelling.
Casting
Getting Started with ProCAST for Stress
This tutorial details the basic requirements for Stress Modeling with ProCAST.
Casting
Getting Started with ProCAST for CAFE
The goal of this tutorial is to show a typical grain modeling approach for an equiaxed Investment Casting component using CAFE.
Casting
Getting Started with ProCAST for Continuous Casting
The goal of this tutorial is to show the different approaches for modelling Continuous Casting process for :
Single motion : strand has a single translation or a single curvature deployment
Multiple motions : strand has a combination of translations , curvatures or a mix of them
Casting
Getting Started with ProCAST Crucible Filling
The goal of this tutorial is to show how to set up a process of Gravity Casting using a filling Crucible.
Casting