Tips & Tricks

e-café #3- Modélisation des opérations de poteyage et soufflage à l’aide Quik CAST™

Modélisation des opérations de poteyage et soufflage à l’aide Quik CAST™

3D Combine

As existing 2D Combine in Visual-Mesh, 3D Combine has been introduced to undone refinements.

Geometrical drawbeads with Design Table

CATIA V5 offers powerful functionality to modify existing geometry “from outside” via DESIGN TABLE. PAM DIEMAKER for CATIA V5 also supports this procedure with some prerequisites.

New pattern in Visual-Mesh 3D split

The aim of this new 3D pattern is to allow users to refine mesh on a restricted area

How to use Blank Holder functionality in PAM-DIEMAKER for CATIA V5

This video shows how to use Blank Holder functionnality to create mono surface Blank Holder shapes and combination of several Blank Holder patches.

How to create a complex blank holder with PAM-DIEMAKER for CATIA V5

This video shows how the complex blank holder of a double action draw die can be created from multiple segments using a combination of standard CATIA and special PAM-DIEMAKER for CATIA V5 functions all available inside the Blank Holder dialog.

Improve trimming with Overshoot

Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.

Trim and Shear Angles

Explanations about Trim and Shear Angles

Crash when launching Visual on CentOS

On Linux, at moment of launching Visual-Environmnet, crash happens after having selected Visual Weld. It is possible to try following steps to solve the problem. - Launching Visual in debug mode - Downgrade GlibC to 2.12 - Install freshly NTP

『MODULAR MATERIAL MODELING』

Visual-Viewer 12.5ではモジュラーマテリアルに対応するGUIが導入されました。