Tips & Tricks

Some possible problems with CNTAC or TIED definitions

This tip discusses some of the reasons that might be responsible for problems with contact or tied definitions in a VPS simulation

Relation between Bulk Modulus K, Shear Modulus G, Young's Modulus E and Poisson's ratio ν

This tip explains the relations between the parameters that describe the linear elastic behavior of materials

How to convert force-deflection into true stress-strain curves?

This tip helps to convert typical tensile test data into stress-strain curves to be used in many material models of Virtual Performance Solution (VPS)

Clipping Plane Parameters (USER)

The clipping plane functionality allows the user to increase the performance of his session. Some geometries can cause problems with the default clipping parameters. This article will explain some hints to avoid such problems.

How to update the ProcessControl? (ADMINISTRATOR)

This document explains how to update the ProcessControl Software of your Virtual Reality Cluster.

Internal injection lines modeling

Internal injection lines on a shell model (i.e. made of internal element edges) are not supported by the parallel solver.

Direct Opening of a mesh

The creation of a RTM project and loading of the model mesh is usually done in 2 steps.

Coupling between PAM-FORM and PAM-RTM: multiple part mapping

Coupling between PAM-FORM 2G and PAM-RTM is done through a .DSY file. Thus, pre-forming process is simulated with PAM-FORM 2G and resulting fiber orientations that will affect permeabilities are transferred to PAM-RTM model setup.