Tips & Tricks

How to use Blank Holder functionality in PAM-DIEMAKER for CATIA V5

This video shows how to use Blank Holder functionnality to create mono surface Blank Holder shapes and combination of several Blank Holder patches.

Delta T Offset For Bowing Effect in Assembly Process

In case of butt joint of two plates, in reality, there is an eccentricity e between the neutral phase of bending and the centre of the tendon force caused by the weld which causes the typical horse saddle of a butt welded flat plate.. A functionality Delta T Offset  has been developed in order to overcome the limitation due to the shrinkage methodology that cannot provide correct results for a butt joint with a non-symmetrical welding. With this new development, it will be possible to apply an offset value on the thermal loading between upper and lower surfaces of shell. In consequence, the horse saddle effect of a butt welded flat plate is produced with Assembly solution.

How to create a complex blank holder with PAM-DIEMAKER for CATIA V5

This video shows how the complex blank holder of a double action draw die can be created from multiple segments using a combination of standard CATIA and special PAM-DIEMAKER for CATIA V5 functions all available inside the Blank Holder dialog.

Improve trimming with Overshoot

Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.

Trim and Shear Angles

Explanations about Trim and Shear Angles

How do I create an SEA cavity using shrinkwrap?

How to create FE acoustic cavities with complex shapes

Auto Empty Folders option in CFD-GEOM

When importing large models into CFD-GEOM, you may notice that certain entities listed in the Model Manager may have a red box around them.

Adding Baffles to an Unstructured domain in CFD-GEOM

While meshing the geometries of industrial significance like mixing tanks, reactor and heat exchangers, we may encounter baffles which have negligible thickness but significant area to impact the physics of the problem in terms of momentum and heat transfer. These surfaces may be free-standing or connected to other surfaces from the domain.

New Mesh Sources in CFD-GEOM for Triangle and Tetrahedral meshing

Corner Point Sources, Surface Interior Sources and Tet Sources have been available in CFD-GEOM for several years, allowing for refinements during certain phases of mesh generation.

How to define height of constraint UDT profile with respect to the Blankholder?

Method to constrain the height of UDT profile bulge with respect to the Blankholder