10 Reinforcement Rail - Double Part

Videos and datas here attached will allow you to learn the following mains steps in Die Face Design with PAM-DIEMAKER for CATIA V5.

Several geometry files are available to well follow each of theses steps.

Reinforcement Rail - Double Part

• Part Definition with the 2 Parts, Flanges Domains identification, Mode Definition as Complete Double Part Mode with Domain Tipping Definition, to identify Master and Slave Part.

• Material Definition, First Part Preparation with Holes Filling, Unfillet Corners, Transition Area Definition between both Parts with Border Curves and Internal Curves. Second Part Preparation with Rolling Cylinder, Partial Part Extension

• Blankholder Definition using Part On Binder, Visualization of the Punch Impact, Check of the Relative Draw Depth on Blankholder Surface created

• First Addendum Frame Definition for an Open Addendum with Start and End Points, Profiles Definition, DOL Definition, Addendum Surface Definition between Profiles using Corner Patch, Corner Patch Fillet with Relimiters

• Second Addendum Frame Definition for an Open Addendum, DOL Definition with Curve 3D edition, Addendum Head Definition with Radius Measure Item, Corner Patch Fillet using Relimiters

• Aggregation of the 2 Corner Patches in Part Preparation. Rolling Cylinder in a new Part Preparation. Part On Binder Ring Surface

• Line Bead Definition using Offset Curve 3D and Limits with Start and End points, Trimming Line Manager with Solver Approach, Blank Outline Definition with Offseted Curve 3D used as Target Curve. Finally Export to PAM-STAMP Definition