Tips & Tricks

e-Café #2 - Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP

Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP

Julien Charbonneaux Sheet Metal Forming

e-café #1 - Réaliser une mise en données en 5 minutes en utilisant le workflow PAMSTAMP

Presse simple effet avec PAMSTAMP

Julien Charbonneaux Sheet Metal Forming

Delta T Offset For Bowing Effect in Assembly Process

In case of butt joint of two plates, in reality, there is an eccentricity e between the neutral phase of bending and the centre of the tendon force caused by the weld which causes the typical horse saddle of a butt welded flat plate.. A functionality Delta T Offset has been developed in order to overcome the limitation due to the shrinkage methodology that cannot provide correct results for a butt joint with a non-symmetrical welding. With this new development, it will be possible to apply an offset value on the thermal loading between upper and lower surfaces of shell. In consequence, the horse saddle effect of a butt welded flat plate is produced with Assembly solution.

Yonggang Duan Welding & Assembly

Improve trimming with Overshoot

Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.

Matthias Hoss Sheet Metal Forming