Tips & Tricks

e-Café #6 - Prédiction des points chauds dans les moules en sable avec ProCAST™

Visualisez les points chauds dans le moule à l’aide de la fonction BurnOn de ProCAST™

e-café #5- Pilotage du refroidissement par thermocouple à l’aide de ProCAST™ et QuikCAST™

Pilotage du refroidissement par thermocouple à l’aide de ProCAST™ et QuikCAST™

e-café #2- Prédiction de la localisation des inclusions de sable à l’aide de ProCAST™

Prédiction de la localisation des inclusions de sable à l’aide de ProCAST™

e-café #1- Détermination de la courbe de déplacement du piston à l’aide de ProCAST™

Détermination de la courbe de déplacement du piston à l’aide de ProCAST™

Delta T Offset For Bowing Effect in Assembly Process

In case of butt joint of two plates, in reality, there is an eccentricity e between the neutral phase of bending and the centre of the tendon force caused by the weld which causes the typical horse saddle of a butt welded flat plate.. A functionality Delta T Offset  has been developed in order to overcome the limitation due to the shrinkage methodology that cannot provide correct results for a butt joint with a non-symmetrical welding. With this new development, it will be possible to apply an offset value on the thermal loading between upper and lower surfaces of shell. In consequence, the horse saddle effect of a butt welded flat plate is produced with Assembly solution.

SEA : License error on the windows client side

License error on the windows client side But ping server works ok...->>Check the client firewall(s)! might have to be off

complex impedance spectrum from an NCT

How do I create a complex impedance spectrum from an NCT?,This can be achieved by using the standard utility script under FE & BEM Utilities > Create > Create Area Isolator from NCT.

Virtual TL: which surface is used in the computation

Virtual TL: which surface is used in the computation The area is obtained by the first layer, emission side.

How do I get sensor values using scripting?

Script prints Real and Imag values of selected sensor Usage: Run the script and specify the output results

Is there a QuickScript function to clear the undo buffer?

Use GUI_SendCommand(33124) It refreshes the 3D window and clears the undo-buffer.