- Home
- Resources
- Tips & Tricks
Tips & Tricks
e-café #3 - Customiser l'interface PAM-STAMP
Vous voulez personnaliser votre environnement de travail avec PAMSTAMP ? Cet e-café vous explique comment customiser l'interface en utilisant un workflow dédié et en utilisant des barres d'outils faites sur mesure.
Julien
Charbonneaux
Sheet Metal Forming
Recommendations to use IRONING option in PAM-STAMP
Several recommendations for ironing
Martin
Holecek
Sheet Metal Forming
e-Café #2 - Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP
Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP
Julien
Charbonneaux
Sheet Metal Forming
e-café #1 - Réaliser une mise en données en 5 minutes en utilisant le workflow PAMSTAMP
Presse simple effet avec PAMSTAMP
Julien
Charbonneaux
Sheet Metal Forming
Interface SYSWELD / ABAQUS
The objective of this interface is to perform a restart with ABAQUS using a SYSWELD computation. The difficulty is to transfer the metallurgical effects in a data structure which is not designed for it.
Yonggang
Duan
Welding & Assembly
How to Obtain Best Results within Reasonable Time from a Heat Treatment Simulation
Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.
Yonggang
Duan
Welding & Assembly
Stamping/HT Chaining of 3D Ring - Restart tool in Visual Heat Treatment
This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by quenching in addition to lowering hardness to within a specified range, or meeting certain mechanical property requirements.
Yonggang
Duan
Welding & Assembly
Heat Power display in Visual Weld
The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding Utilities" menu of Visual Weld.
Yonggang
Duan
Welding & Assembly
Improve trimming with Overshoot
Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.
Matthias
Hoss
Sheet Metal Forming
PAM-STAMP solver 2018.0.1 - Troubleshooting
Recommended file exchange in case of unexpected solver stop without error message. MPI change in case plateform mpi issue in DMP
Martin
Holecek
Sheet Metal Forming