Tips & Tricks

Crash when launching Visual on CentOS

On Linux, at moment of launching Visual-Environmnet, crash happens after having selected Visual Weld. It is possible to try following steps to solve the problem. - Launching Visual in debug mode - Downgrade GlibC to 2.12 - Install freshly NTP

Material Properties visualization

Check material properties on model

Visual-CFD Frequently asked questions with solutions

This article collects several tips & tricks for Visual-CFD users

Cross Section Tool in Visual-SYSTUS

Cross-section creation becomes easy using the brand new Visual-SYSTUS cross-section tool !

Coupling windows for postreatment visualization

When comparison between results is needed, coupling windows and synchronizing animations is a key tool.

Boundary Layer Mesh tool demonstration

Easily creating a connection between a tetramesh and an hexamesh is possible, using Boundary Layer Mesh tool.

Using Region sources in CFD-VisCART

In order to control grid spacing at user-defined locations, mesh sources are a common tool in CFD-VisCART (Figure 1). Point, Line, Curve, Plane, Box and Surface sources have been available for several years. Cylinder and Sphere sources were introduced a few years back. To extend this tool set further, CFD-VisCART V2013.0 introduced Region sources.

Arbitrarily 3D shaped surfaces

This paper illustrates the modeling process to be applied by a Visual-Mesh user with the objective of creating one arbitrarily 3D shaped surface starting from scratch.

How to fill multiple holes of different shapes and sizes on a plate?

Using Visual-Mesh, you can fill small holes of different diameters with a surface easily. This can be achieved with the Surface Trim option available in the surface menu.

How does Batch Mode execution work in Visual-Environment?

To run the scripts in Batch mode