Tips & Tricks

e-Café #6 - Prédiction des points chauds dans les moules en sable avec ProCAST™

Visualisez les points chauds dans le moule à l’aide de la fonction BurnOn de ProCAST™

e-café #5- Pilotage du refroidissement par thermocouple à l’aide de ProCAST™ et QuikCAST™

Pilotage du refroidissement par thermocouple à l’aide de ProCAST™ et QuikCAST™

e-café #2- Prédiction de la localisation des inclusions de sable à l’aide de ProCAST™

Prédiction de la localisation des inclusions de sable à l’aide de ProCAST™

e-café #1- Détermination de la courbe de déplacement du piston à l’aide de ProCAST™

Détermination de la courbe de déplacement du piston à l’aide de ProCAST™

Delta T Offset For Bowing Effect in Assembly Process

In case of butt joint of two plates, in reality, there is an eccentricity e between the neutral phase of bending and the centre of the tendon force caused by the weld which causes the typical horse saddle of a butt welded flat plate.. A functionality Delta T Offset  has been developed in order to overcome the limitation due to the shrinkage methodology that cannot provide correct results for a butt joint with a non-symmetrical welding. With this new development, it will be possible to apply an offset value on the thermal loading between upper and lower surfaces of shell. In consequence, the horse saddle effect of a butt welded flat plate is produced with Assembly solution.

How to model Cable Networks & Connectors?

This paper is aimed at describing the modeling process to be applied to the terminal connectors of a Cable Network when focusing on 3D/Multiconductor Transmission Lines (MTL) coupling

How to manage small sized Reference Boxes?

This paper is introducing the “–RB” option of the FD mesh generator allowing PAM-CEM/FD users to manage one limited part of a complete CAD model, without any hand-made cleaning stage

How to avoid oscillatory phenomena with short circuited terminals of Cable Networks ?

Cable Networks with short-circuited terminals may exhibit Common-Mode (CM) currents with a highly oscillatory behavior. This article illustrates one solution to eliminate such behavior by considering lossy dielectric coatings varying with the frequency.

FD Interpolating Scheme near Metallic Structures

This article illustrates the PAM-CEM/FD interpolation scheme applied to compute the tangential electric field along wires’ path running near metallic structures (and aimed at avoiding the management of field components on both sides of the surface).

3D/Multiconductor Transmission Lines (MTL) Coupling VS. Stand-Alone FDTD (Accuracy)

This article is aimed at comparing the 3D/Multiconductor Transmission Lines (MTL) coupling accuracy with the PAM-CEM/FD stand-alone use, when applied to simplified wired models. Recommendations for good agreement are also proposed.