Tips & Tricks

Which moments of inertia to use in added mass (MASS / ) cards ?

This tip discusses the choice of physically meaningful numbers to be used, when moments of inertia need to be specified in an added mass definition.

Some possible problems with CNTAC or TIED definitions

This tip discusses some of the reasons that might be responsible for problems with contact or tied definitions in a VPS simulation

Relation between Bulk Modulus K, Shear Modulus G, Young's Modulus E and Poisson's ratio ν

This tip explains the relations between the parameters that describe the linear elastic behavior of materials

How to convert force-deflection into true stress-strain curves?

This tip helps to convert typical tensile test data into stress-strain curves to be used in many material models of Virtual Performance Solution (VPS)

Model clipping feature in CFD-VisCART and CFD-GEOM

For better visualization of the geometry and mesh, a model clipping feature was introduced in CFD-VisCART and CFD-GEOM V2013.0. The following sections illustrate the usage and benefits of this feature.

Improve Productivity Using Scripts [Video Format]

As simulations become more integrated with the design process, engineers often spend time on repeated operations that do not contribute to their productivity. There is a need for tools that could capture, preserve and transfer the knowledge within the organization or to its customers.

Boundary layer meshing with CFD-ACE+ [video format]

The accuracy of a CFD solution is strongly dependent on how well the mesh resolves geometry and flow features. This is especially true for near wall regions (boundary layer) where viscous forces are not negligible compared to inertial forces.

How to check what software version you are running

There is a very fast and easy way to verify what software version you are running for your ESI CFD applications. You most likely know that this information is available for the GUI by clicking on 'Help → About ...', and for solvers by looking in the output file.

Always Make Sure You Have a Good Mesh Quality

The mesh has a great influence on the solver convergence and solution of every CFD Simulation. The user is strongly advised to check the quality of a numerical mesh.

Copy/Paste Viewpoint tools

Usually, when performing a particular simulation, it is necessary to compare the results of similar models or the same model at different operating conditions. It is important that the two (or more) cases being compared be viewed from the same angle and at the same zoom level.