Tips & Tricks

How to use Blank Holder functionality in PAM-DIEMAKER for CATIA V5

This video shows how to use Blank Holder functionnality to create mono surface Blank Holder shapes and combination of several Blank Holder patches.

Delta T Offset For Bowing Effect in Assembly Process

In case of butt joint of two plates, in reality, there is an eccentricity e between the neutral phase of bending and the centre of the tendon force caused by the weld which causes the typical horse saddle of a butt welded flat plate.. A functionality Delta T Offset  has been developed in order to overcome the limitation due to the shrinkage methodology that cannot provide correct results for a butt joint with a non-symmetrical welding. With this new development, it will be possible to apply an offset value on the thermal loading between upper and lower surfaces of shell. In consequence, the horse saddle effect of a butt welded flat plate is produced with Assembly solution.

How to create a complex blank holder with PAM-DIEMAKER for CATIA V5

This video shows how the complex blank holder of a double action draw die can be created from multiple segments using a combination of standard CATIA and special PAM-DIEMAKER for CATIA V5 functions all available inside the Blank Holder dialog.

Improve trimming with Overshoot

Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.

Trim and Shear Angles

Explanations about Trim and Shear Angles

Crash when launching Visual on CentOS

On Linux, at moment of launching Visual-Environmnet, crash happens after having selected Visual Weld. It is possible to try following steps to solve the problem. - Launching Visual in debug mode - Downgrade GlibC to 2.12 - Install freshly NTP

Visual-CFD Frequently asked questions with solutions

This article collects several tips & tricks for Visual-CFD users

Coupling windows for postreatment visualization

When comparison between results is needed, coupling windows and synchronizing animations is a key tool.

Boundary Layer Mesh tool demonstration

Easily creating a connection between a tetramesh and an hexamesh is possible, using Boundary Layer Mesh tool.

Arbitrarily 3D shaped surfaces

This paper illustrates the modeling process to be applied by a Visual-Mesh user with the objective of creating one arbitrarily 3D shaped surface starting from scratch.