- Home
- Resources
- Tips & Tricks
Tips & Tricks
Recommendations to use IRONING option in PAM-STAMP
Several recommendations for ironing
Martin
Holecek
Sheet Metal Forming
e-Café #2 - Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP
Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP
Julien
Charbonneaux
Sheet Metal Forming
e-café #1 - Réaliser une mise en données en 5 minutes en utilisant le workflow PAMSTAMP
Presse simple effet avec PAMSTAMP
Julien
Charbonneaux
Sheet Metal Forming
Modelling pretension of Bolts
To simulate bolt pretension, a new medium called PRELOAD has been developed. With this medium, the strain generating the pretension is automatically computed and applied on the model.
Sandrine
Dischert
Multiphysics
3D Combine
As existing 2D Combine in Visual-Mesh, 3D Combine has been introduced to undone refinements.
Sandrine
Dischert
Multiphysics, Virtual Integration Platform
New pattern in Visual-Mesh 3D split
The aim of this new 3D pattern is to allow users to refine mesh on a restricted area
Sandrine
Dischert
Multiphysics, Virtual Integration Platform
Computation Manager - Basic & Advanced mode
The computation manager help users to generate the computation input with parameters adapted to the model to study
Sandrine
Dischert
Multiphysics
Delta T Offset For Bowing Effect in Assembly Process
In case of butt joint of two plates, in reality, there is an eccentricity e between the neutral phase of bending and the centre of the tendon force caused by the weld which causes the typical horse saddle of a butt welded flat plate.. A functionality Delta T Offset has been developed in order to overcome the limitation due to the shrinkage methodology that cannot provide correct results for a butt joint with a non-symmetrical welding. With this new development, it will be possible to apply an offset value on the thermal loading between upper and lower surfaces of shell. In consequence, the horse saddle effect of a butt welded flat plate is produced with Assembly solution.
Yonggang
Duan
Welding & Assembly
Improve trimming with Overshoot
Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.
Matthias
Hoss
Sheet Metal Forming
PAM-STAMP solver 2018.0.1 - Troubleshooting
Recommended file exchange in case of unexpected solver stop without error message. MPI change in case plateform mpi issue in DMP
Martin
Holecek
Sheet Metal Forming