Tips & Tricks

e-Café #7 - Maillage volumique avec Visual-CAST™ 16.0

Créez le maillage volumique à l’aide de la fonction Grid Definition dans Visual-CAST™ 16.0

e-café #5- Pilotage du refroidissement par thermocouple à l’aide de ProCAST™ et QuikCAST™

Pilotage du refroidissement par thermocouple à l’aide de ProCAST™ et QuikCAST™

e-café #4- Modélisation de l’emballage (Wrap) à l’aide de ProCAST™

Modélisation de l’emballage (Wrap) à l’aide de ProCAST™

e-café #3- Modélisation des opérations de poteyage et soufflage à l’aide Quik CAST™

Modélisation des opérations de poteyage et soufflage à l’aide Quik CAST™

3D Combine

As existing 2D Combine in Visual-Mesh, 3D Combine has been introduced to undone refinements.

New pattern in Visual-Mesh 3D split

The aim of this new 3D pattern is to allow users to refine mesh on a restricted area

Interface SYSWELD / ABAQUS

The objective of this interface is to perform a restart with ABAQUS using a SYSWELD computation. The difficulty is to transfer the metallurgical effects in a data structure which is not designed for it.

How to Obtain Best Results within Reasonable Time from a Heat Treatment Simulation

Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.

Stamping/HT Chaining of 3D Ring - Restart tool in Visual Heat Treatment

This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by quenching in addition to lowering hardness to within a specified range, or meeting certain mechanical property requirements.

Heat Power display in Visual Weld

The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding Utilities" menu of Visual Weld.