Tips & Tricks

Trim and Shear Angles

Explanations about Trim and Shear Angles

Managing Multiple STAGE with Virtual Performance Solution (VPS)

This tip provides some information on the usage of multi stage runs in Virtual Performance Solution (VPS)

Using Inertial Relief

This tip provides some background information on how to model static cases without considering the effect of boundary conditions in Virtual Performance Solution (VPS)

Preloading BOLTS

This tip provides methodology to pre stress elements in Virtual Performance Solution (VPS) to model Bolt assemblies.

Using Region sources in CFD-VisCART

In order to control grid spacing at user-defined locations, mesh sources are a common tool in CFD-VisCART (Figure 1). Point, Line, Curve, Plane, Box and Surface sources have been available for several years. Cylinder and Sphere sources were introduced a few years back. To extend this tool set further, CFD-VisCART V2013.0 introduced Region sources.

How to define height of constraint UDT profile with respect to the Blankholder?

Method to constrain the height of UDT profile bulge with respect to the Blankholder

How to define tipping for free double parts with existing forming direction?

Recommendation to position properly the free double parts in case the forming direction is predefined.

How to get back the hidden Part Definition after accepting dialogue?

Option to deactivate to get back the hidden part definition after accepting dialogue.

How to improve the update performance on iterations?

Recommendation to optimize the update performance during iterations.

Hints on the usage of linear Tetrahedron (TETR4 / ) elements

This tip provides some background information on the question, when, or when not, to use the linear tetrahedron (TETR4 / ) element in Virtual Performance Solution (VPS)