Tips & Tricks

Visual-Environment Highlight of Visual-Seat: STAN Thermal Dummy

STAN is a thermal dummy to test thermal comfort and moisture management characteristics of automobile, truck, and airplane seating. This device is commercialized by Thermetrics® and some relevant information can be found here: https://thermetrics.com/products/manikin/stan/. In collaboration with Thermetrics, ESI developed a numerical model of the STAN dummy for the prediction of its thermal behavior. No humidity is managed in this version of the model. A process for the setup of the seating and the thermal simulations of the STAN dummy have been added in this version.

Visual-Environment Highlight of Visual-Seat: Sewing Simulation Guided Setup

Sewing simulations aim at assembling flat cover patterns and wrapping them around deformable foam block. This application exists in Visual-Seat for many versions as a set of toolboxes and functionalities enabling to set-up this type of input. This has been enhanced with a workflow gathering all tools and functionalities and proposing them in the right sequential order to provide some user guidance.

Visual-Environment Highlight of Visual-Seat: Foam Blocks Positioning

When assembling the different components of the seat, it may happen that the foam at rest is intersecting the frame and/or the suspensions. In order to remove those intersections, a simulation-based technique had been implemented previously by applying surface pressure on foam. Upon customer request, a new method has been added where the frame (and suspensions) can be scaled down and moved initially to retrieve progressively their size and position during simulation, when the contact with foam is active.

Recommendations to use IRONING option in PAM-STAMP

Several recommendations for ironing

e-Café #2 - Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP

Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP

e-café #1 - Réaliser une mise en données en 5 minutes en utilisant le workflow PAMSTAMP

Presse simple effet avec PAMSTAMP

3D Combine

As existing 2D Combine in Visual-Mesh, 3D Combine has been introduced to undone refinements.

New pattern in Visual-Mesh 3D split

The aim of this new 3D pattern is to allow users to refine mesh on a restricted area

Improve trimming with Overshoot

Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.

PAM-STAMP solver 2018.0.1 - Troubleshooting

Recommended file exchange in case of unexpected solver stop without error message. MPI change in case plateform mpi issue in DMP