Tips & Tricks

How to change user home location in Visual-Environment?

You can change the Home and Temporary directory path from General Preference or from the Variables

How to make an advanced selection in Visual-Environment?

Advanced Selection allows you to select entities in different ways such as column wise, sheet wise, etc. It also allows you to stop the selection at non manifold T-Sections based on feature angle.

How to create your own toolbar in PAM-STAMP?

This tutorial is to help users to create their own custom toolbar, and then to shows how to share it with others.

Internal injection lines modeling

Internal injection lines on a shell model (i.e. made of internal element edges) are not supported by the parallel solver.

Direct Opening of a mesh

The creation of a RTM project and loading of the model mesh is usually done in 2 steps.

Coupling between PAM-FORM and PAM-RTM: multiple part mapping

Coupling between PAM-FORM 2G and PAM-RTM is done through a .DSY file. Thus, pre-forming process is simulated with PAM-FORM 2G and resulting fiber orientations that will affect permeabilities are transferred to PAM-RTM model setup.

How to fix grey selection window in PAM-STAMP GUI ?

Using default setup of AERO themes in Windows 7 and Vista creates problems for selection by window in PAM-STAMP GUI. There are instructions how to setup your Windows to avoid that problem.

Make an independent setup from existing pre and rst files in PAM-STAMP

Sometimes only rst files there are available and dependent pre file of an intermediate stage setup (lost data, picking with a process variant, …), which is not possible to run in another PAM-STAMP version, usually in newer version. It is possible to create a pre file independent on preceding rst files.

Determination of Krupkowsky parameters for hardening curve

In case there are no measured material data for simulation purposes, it is possible to determine hardening curve from information usually provided by material supplier.

How to import a PAM-STAMP result into CATIA V5 with VRML export format ?

For a comparison of the virtual stamped part and the nominal CATIA V5 part one can use PAM-STAMP, or go back to CATIA. Since the meshed part is not easily converted into surfaces again, one solution is to use an overlay of the CAD part and of a VRML export of the stamp part.