Tips & Tricks

e-café #3 - Customiser l'interface PAM-STAMP

Vous voulez personnaliser votre environnement de travail avec PAMSTAMP ? Cet e-café vous explique comment customiser l'interface en utilisant un workflow dédié et en utilisant des barres d'outils faites sur mesure.

Recommendations to use IRONING option in PAM-STAMP

Several recommendations for ironing

e-Café #2 - Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP

Réaliser la compensation géométrique de l'outillage de façon automatique avec PAMSTAMP

e-café #1 - Réaliser une mise en données en 5 minutes en utilisant le workflow PAMSTAMP

Presse simple effet avec PAMSTAMP

Interface SYSWELD / ABAQUS

The objective of this interface is to perform a restart with ABAQUS using a SYSWELD computation. The difficulty is to transfer the metallurgical effects in a data structure which is not designed for it.

How to Obtain Best Results within Reasonable Time from a Heat Treatment Simulation

Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.

Stamping/HT Chaining of 3D Ring - Restart tool in Visual Heat Treatment

This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by quenching in addition to lowering hardness to within a specified range, or meeting certain mechanical property requirements.

Heat Power display in Visual Weld

The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding Utilities" menu of Visual Weld.

Improve trimming with Overshoot

Trimming in PAM-STAMP can fail due to a too short trimming segment curve leading to not cut properly the blank mesh. This can be solved by using Overshoot option in PAM-DIEMAKER for CATIA V5.

PAM-STAMP solver 2018.0.1 - Troubleshooting

Recommended file exchange in case of unexpected solver stop without error message. MPI change in case plateform mpi issue in DMP