Tips & Tricks

How to Obtain Best Results within Reasonable Time from a Heat Treatment Simulation

Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.

Stamping/HT Chaining of 3D Ring - Restart tool in Visual Heat Treatment

This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by quenching in addition to lowering hardness to within a specified range, or meeting certain mechanical property requirements.

Heat Power display in Visual Weld

The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding Utilities" menu of Visual Weld.

Conversion Files .fdb in .erfh5 on Network Drive

It is not straightforward to do the conversion Files .fdb in .erfh5 on Network Drive in Visual Viewer. In order to make it work properly, it is necessary to map network drive to the local machine. In this way, the files on network could be handled like on local machine and the conversion from fdb to erf will be working properly.

Coupling windows for postreatment visualization

When comparison between results is needed, coupling windows and synchronizing animations is a key tool.

Boundary Layer Mesh tool demonstration

Easily creating a connection between a tetramesh and an hexamesh is possible, using Boundary Layer Mesh tool.

Heat Sources in Sysweld

From finite element point of view, a heat source is modelled in SYSWELD by a volume density of energy named Qr (W/mm3) applied to elements, which move along the welding trajectory.

How to model Cable Networks & Connectors?

This paper is aimed at describing the modeling process to be applied to the terminal connectors of a Cable Network when focusing on 3D/Multiconductor Transmission Lines (MTL) coupling

How to avoid oscillatory phenomena with short circuited terminals of Cable Networks ?

Cable Networks with short-circuited terminals may exhibit Common-Mode (CM) currents with a highly oscillatory behavior. This article illustrates one solution to eliminate such behavior by considering lossy dielectric coatings varying with the frequency.

FD Interpolating Scheme near Metallic Structures

This article illustrates the PAM-CEM/FD interpolation scheme applied to compute the tangential electric field along wires’ path running near metallic structures (and aimed at avoiding the management of field components on both sides of the surface).