Tips & Tricks

How can I batch update the connection between an SEA subsystems and a SIF?

This can in most cases be achieved by using the utility "Connect Semi-Infinite Fluid" script available with in VA One.

Can I set the angle for a DAF applied on an SEA panel?

The angle can be set for an NCT, so a workaround is to use a "gap" NCT and set the angle for this NCT

Split a flat FE face

How can I split a flat FE face?, A way to split a FE face manually is to use the script "General > Create >Create FE Geometry from Selection".

I get a Target Cluster Full error - what does it mean?

It is a known issue in 2013 with a large number of frequencies being recovered at a large number of nodes

Radiation from ribbed plates

There are here two competing phenomena in the structural-acoustic behavior of bare plates versus ribbed plates:

Why would one want to use the Efimtsov model instead of the Cockburn/Robertson model for a TBL source?

From Graham: the main advantage of the Efimtsov versus the Cockburn/Robertson model is that it accounts for the dependence of the decay coefficients (i.e. correlation length) on boundary layer thickness.

Can VA One import FE NASTRAN models with superelements defined?

VA One can import FE models with superelements (SE) defined...

Does VA One SEA use cached data when solving in batch mode?

Does VA One SEA use cached data when solving in batch mode?, Yes, with a .va1 as input to the batch solve, VA One SEA will use the CLF's cached in that .va1 if they exist.

Negative Pin into a BEM fluid

I see negative Pin into a BEM fluid - what may be the reason?,This was a known issue for cases with heavy fluids

MUMPS error when solving my SEA model

I'm getting a MUMPS error when solving my SEA model - what may be the cause?, Reason for this is un-allowed or un-physical combination of physical properties in some NCTs. Correct those and the solve should go through.