Tips & Tricks

Visual-Environment Highlight of Visual-Seat: Sewing Simulation Guided Setup

Sewing simulations aim at assembling flat cover patterns and wrapping them around deformable foam block. This application exists in Visual-Seat for many versions as a set of toolboxes and functionalities enabling to set-up this type of input. This has been enhanced with a workflow gathering all tools and functionalities and proposing them in the right sequential order to provide some user guidance.

Visual-Environment Highlight of Visual-Seat: Foam Blocks Positioning

When assembling the different components of the seat, it may happen that the foam at rest is intersecting the frame and/or the suspensions. In order to remove those intersections, a simulation-based technique had been implemented previously by applying surface pressure on foam. Upon customer request, a new method has been added where the frame (and suspensions) can be scaled down and moved initially to retrieve progressively their size and position during simulation, when the contact with foam is active.

3D Combine

As existing 2D Combine in Visual-Mesh, 3D Combine has been introduced to undone refinements.

New pattern in Visual-Mesh 3D split

The aim of this new 3D pattern is to allow users to refine mesh on a restricted area

Delta T Offset For Bowing Effect in Assembly Process

In case of butt joint of two plates, in reality, there is an eccentricity e between the neutral phase of bending and the centre of the tendon force caused by the weld which causes the typical horse saddle of a butt welded flat plate.. A functionality Delta T Offset  has been developed in order to overcome the limitation due to the shrinkage methodology that cannot provide correct results for a butt joint with a non-symmetrical welding. With this new development, it will be possible to apply an offset value on the thermal loading between upper and lower surfaces of shell. In consequence, the horse saddle effect of a butt welded flat plate is produced with Assembly solution.

Crash when launching Visual on CentOS

On Linux, at moment of launching Visual-Environmnet, crash happens after having selected Visual Weld. It is possible to try following steps to solve the problem. - Launching Visual in debug mode - Downgrade GlibC to 2.12 - Install freshly NTP

Visual-CFD Frequently asked questions with solutions

This article collects several tips & tricks for Visual-CFD users

Coupling windows for postreatment visualization

When comparison between results is needed, coupling windows and synchronizing animations is a key tool.

Boundary Layer Mesh tool demonstration

Easily creating a connection between a tetramesh and an hexamesh is possible, using Boundary Layer Mesh tool.

Arbitrarily 3D shaped surfaces

This paper illustrates the modeling process to be applied by a Visual-Mesh user with the objective of creating one arbitrarily 3D shaped surface starting from scratch.