Tips & Tricks

How do I create an SEA cavity using shrinkwrap?

How to create FE acoustic cavities with complex shapes

Auto Empty Folders option in CFD-GEOM

When importing large models into CFD-GEOM, you may notice that certain entities listed in the Model Manager may have a red box around them.

Adding Baffles to an Unstructured domain in CFD-GEOM

While meshing the geometries of industrial significance like mixing tanks, reactor and heat exchangers, we may encounter baffles which have negligible thickness but significant area to impact the physics of the problem in terms of momentum and heat transfer. These surfaces may be free-standing or connected to other surfaces from the domain.

Using Region sources in CFD-VisCART

In order to control grid spacing at user-defined locations, mesh sources are a common tool in CFD-VisCART (Figure 1). Point, Line, Curve, Plane, Box and Surface sources have been available for several years. Cylinder and Sphere sources were introduced a few years back. To extend this tool set further, CFD-VisCART V2013.0 introduced Region sources.

New Mesh Sources in CFD-GEOM for Triangle and Tetrahedral meshing

Corner Point Sources, Surface Interior Sources and Tet Sources have been available in CFD-GEOM for several years, allowing for refinements during certain phases of mesh generation.

Automatic covering of larger unwanted holes in CFD-VisCART

CFD-VisCART meshing automatically closes or covers holes in the geometry that are smaller in size than the cell size specified at the surfaces. To cover LARGER holes, the ‘Max Hole Size to Cover’ feature can be used. This feature, introduced in V2013.2, works to automatically cover larger holes in the geometry during mesh generation, and thus prevents the mesh from leaking into unwanted regions. This feature is available with all mesh types supported in CFD-VisCART.

Working with Solids in CFD-GEOM - Part 1: Boolean Operations

Given that today’s users may import several complex parts into CFD-GEOM, this tip will demonstrate how to use the Solid Boolean Union Option to combine several parts into one.

Grouping parts during data import in CFD-VisCART

When dealing with complex industrial models such as cars and airplanes, hundreds of parts need to be managed. Each one of these parts may also be subdivided into different components. In order to easily manipulate these different parts and components in CFD-VisCART, you can make use of the grouping feature.

CFD-VisCART: Mesh Extrusion

In most CFD simulations, it is required to place inlets/outlets far enough from the region of interest in order to reduce their influence on the solution. In many applications, this can be done by extruding existing inlets/outlets BC patches away from the domain.

Preserving boundaries between patches with CFD-VisCART’s Single Domain mesher

The ‘Preserve Features’ option does very well in preserving features between geometry patches – as long as the patches are not coplanar (dihedral angle = 0) or include a very small dihedral angle between them.