Tips & Tricks

Here you will find articles on how to solve specific issues related to ESI's software solutions. Missing ESI products will be added progressively. Each article has a short abstract which is accessible to everyone. As logged users you can see the full article with all attached screenshots, and you can post comments related to each article.

e-café #8 - Customiser ses paramètres de simulations dans ProCAST™
Créez votre propre liste de paramètres customisés lors de la définition des Simulations parameters
Mathieu Moerckel
Casting
7

e-Café #6 - Prédiction des points chauds dans les moules en sable avec ProCAST™
Visualisez les points chauds dans le moule à l’aide de la fonction BurnOn de ProCAST™
Mathieu Moerckel
Casting
3

e-café #5- Pilotage du refroidissement par thermocouple à l’aide de ProCAST™ et QuikCAST™
Pilotage du refroidissement par thermocouple à l’aide de ProCAST™ et QuikCAST™
Mathieu Moerckel
Casting
13

e-café #2- Prédiction de la localisation des inclusions de sable à l’aide de ProCAST™
Prédiction de la localisation des inclusions de sable à l’aide de ProCAST™
Mathieu Moerckel
Casting
9

e-café #1- Détermination de la courbe de déplacement du piston à l’aide de ProCAST™
Détermination de la courbe de déplacement du piston à l’aide de ProCAST™
Mathieu Moerckel
Casting
8

Interface SYSWELD / ABAQUS
The objective of this interface is to perform a restart with ABAQUS using a SYSWELD computation. The difficulty is to transfer the metallurgical effects in a data structure which is not designed for it.
Yonggang Duan
Welding & Assembly
84

How to Obtain Best Results within Reasonable Time from a Heat Treatment Simulation
Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.
Yonggang Duan
Welding & Assembly
35

Stamping/HT Chaining of 3D Ring - Restart tool in Visual Heat Treatment
This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by...
Yonggang Duan
Welding & Assembly
36

Heat Power display in Visual Weld
The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding...
Yonggang Duan
Welding & Assembly
41

Conversion Files .fdb in .erfh5 on Network Drive
It is not straightforward to do the conversion Files .fdb in .erfh5 on Network Drive in Visual Viewer. In order to make it work properly, it is necessary to map network drive to the local machine. In this way, the files on network could be handled like on local...
Yonggang Duan
Multiphysics, Welding & Assembly
65