CFD-ACE+
ProCAST
PAM-FORM
CRIPTE
SYSTUS
PAM-DIEMAKER for CATIA V5
VA One
Visual-Environment
Virtual Performance Solution
IC.IDO
Virtual Seat Solution
SYSWELD
Here you will find articles on how to solve specific issues related to ESI's software solutions. Missing ESI products will be added progressively. Each article has a short abstract which is accessible to everyone. As logged users you can see the full article with all attached screenshots, and you can post comments related to each article.
Heat treated parts are in most cases not clamped during heat treatment, for an FEM analysis, at least a static determined clamping is needed that does not allow any rigid body motion.
This article is to show effects of heat treatment on stresses when industrial mechanical parts are stamped (or welded) by 3 typical heat treatment steps: Heating, Quenching and Tempering. Tempering is generally considered effective in relieving stresses induced by...
The aim of this development in Visual Weld 14.5 + Sysweld 2019.0 is to display the Power Density. Currently, this functionality is only available in the old SysWeld GUI. The new functionality "Heat Power Display" is available through the "Welding...
It is not straightforward to do the conversion Files .fdb in .erfh5 on Network Drive in Visual Viewer.
In order to make it work properly, it is necessary to map network drive to the local machine. In this way, the files on network could be handled like on local...
On Linux, at moment of launching Visual-Environmnet, crash happens after having selected Visual Weld.
It is possible to try following steps to solve the problem.
- Launching Visual in debug mode
- Downgrade GlibC to 2.12
- Install freshly NTP
Easily creating a connection between a tetramesh and an hexamesh is possible, using Boundary Layer Mesh tool.
How to create FE acoustic cavities with complex shapes
When importing large models into CFD-GEOM, you may notice that certain entities listed in the Model Manager may have a red box around them.
While meshing the geometries of industrial significance like mixing tanks, reactor and heat exchangers, we may encounter baffles which have negligible thickness but significant area to impact the physics of the problem in terms of momentum and heat transfer. These...
Corner Point Sources, Surface Interior Sources and Tet Sources have been available in CFD-GEOM for several years, allowing for refinements during certain phases of mesh generation.